EN
.
66
Endpoint 4:
Device Class:
ZWAVEPLUS_INFO_REPORT_ROLE_TYPE_SLAVE_ALWAYS_0N
GENERIC_TYPE_SENSOR_MULTILEVEL
SPECIFIC_TYPE_ROUTING_SENSOR_MULTILEVEL
Command Classes:
COMMAND_CLASS_ZWAVEPLUS_INFO_V2
COMMAND_CLASS_VERSION_V2
COMMAND_CLASS_ASSOCIATION_V2
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V3
COMMAND_CLASS_ASSOCIATION_GRP_INFO_V2
COMMAND_CLASS_SENSOR_MULTILEVEL_V7
NOTE 1: The Endpoint 4 command class list only applies if an external digital temperature sensor
(sold separately) is connected to the TS terminal. If the sensor is not connected, the following
command class is not supported by the device:
COMMAND_CLASS_SENSOR_MULTILEVEL_V7
This device can be included and operated in any Z-Wave network with other Z-Wave certified
devices from any other manufacturers. All constantly powered nodes in the same network will
act as repeaters regardless of the vendor in order to increase reliability of the network.
NOTE2: The device supports the following
COMMAND_CLASS_NOTIFICATION_V5events:
- Smoke Alarm v2
–
Smoke detected, unknown location (0x02)
- CO Alarm v2
–
Carbon Monoxide detected, unknown location (0x02)
- CO2Alarm
–
Carbon Dioxide detected, unknown location (0x02)
- Heat Alarm v2
–
Overheat detected, unknown location (0x02)
- Water Alarm v2
–
Water Leak detected, unknown location (0x02)
- Home Security
–
Motion Detection, unknown location (0x08)
Summary of Contents for ZMNHAD1
