Qubic System QS-210, User Manual

Page: 17 / 50

QS-210
3. SETUP AND INSTALLATION
3.1. BEFORE INSTALLATION
Qubic System DOES NOT approve exceeding or ignoring any of the points below and IS
NOT responsible for malfunctions, failures or injuries that are results of these actions :
WARNING
Dangerous voltage level may occur in the QS-SB2 power
cabinet and connected cables during the operation and for
a few minutes after turning off the machine. Do not touch
the device when the power switch is on.
WARNING
■
Cables must not be stretched and should be kept in a way that prevents
them from getting under the actuator or any part that can crush or tear
them.
■
DO NOT place down the actuators on the cable side on any surface, always
place them down with cable side up to avoid cable damages.
User Manual R1 09/2023 17