© Qube Engineering 2009
Qube’s AP1 LED Dash DIY Kit Supplemental Instructions Page 14
31)
Heat the soldering iron. Melt a small
drop of solder on the tip of the hot soldering
iron. Touch the hot drop of solder to the
exposed wire trace just until the solder sticks
to the exposed trace. You should not need
to touch the filament with the soldering iron
directly, just with the hot drop of solder. It
should only take a split second. DO NOT
OVERHEAT THE TRACE FILAMENT.
32)
Install the modified upper trace filament
back onto the plastic gauge cluster housing.
33)
Apply soldering flux and a hot drop of
solder to the exposed end of the yellow wire
coming from the LED Array board. Solder
the yellow wire onto the solder drop you
placed on the trace filament. AGAIN, DO
NOT OVERHEAT THE FILAMENT. Turn off the
soldering iron when done with this step.
34)
Install three dark grey based bulbs and
two brown based bulbs as shown. You will
not use the three light grey or two red based
bulbs.
BROWN
DARK GREY