Quattro Titanium, Installation Manual

Page: 12 / 140

EN 11
Introduction
Fitting Guidelines
Specification
Thank you for choosing this caravan mover. This product has been produced according to high
standards and has undergone careful quality control procedures. Simply by using the remote control
you can move your caravan effortlessly into any position required within operating guidelines.
Before proceeding with installation and starting to use the mover, please read this manual
very carefully and be aware of all the safety instructions! The owner of the caravan will
always be responsible for correct use. Keep this manual inside your caravan for
future reference.
This installation manual covers two models of Caravan Mover: EM4446 - Ego Enduro and EGO400
- Quattro Titanium. Any differences between the models are detailed where appropriate. The mover
system consists of two 12V motor-powered rollers, a 12V electronic control box and a remote control.
To function, the motor-powered rollers must be engaged against the tyres of your caravan. The cross
actuation system enables you to simultaneously engage the rollers of both movers. Once this is done the
mover is ready for operation. The remote control will allow you to move your caravan in any direction.
Please be aware that certain installations in Germany are subject to further technical requirements
than in the rest of Europe. If after installation the caravan mover has easily accessible exposed
sharp edges not covered by the caravan bodywork, it is likely that an additional cover will need to be
installed. Please contact Purple Line for further assistance and see ‘Optional fitting adapters’ where
these optional covers are listed with installation explained.
The chassis clamps provided with this system are suitable for fitting onto most standard caravan
chassis that have an L-shape or U-shape profile (Fig.11). Please refer to Fig.13 for reference on
dimensions and clearances BEFORE you proceed any further with installation. If your chassis has
different dimensions to those shown in Fig.13 then various chassis clamp adapters are available to
suit the majority of UK and Continental caravans; please refer to the section of this manual entitled
‘Optional Fitting Adapters’.
* Average Current Consumption readings when using an approx. 1100kg single axle caravan on a
hard, level surface.
** Maximum Current Consumption readings when using an approx. 1100kg single axle caravan
ascending a 1:4 (25%) gradient.
Model Number EGO400 EM4446
Operational Voltage 12V DC 12V DC
Average Current Consumption * 25A (approx.) 25A (approx.)
Maximum Current Consumption ** 120A 120A
Speed 12cm/s (approx.) 9cm/s (approx.)
Approx. Net Weight (inc. all fixings & accessories) 35 kg 40 kg
Safe Working Load (SWL) Twin Motor/Quad Motor 2250kg / 3500kg 2250kg / 3500kg
Minimum Width (caravan/trailer) 1800mm 1800mm
Maximum Width (caravan/trailer) 2500mm 2500mm
Power Source (caravan leisure battery) 12V 12V