Quark-Elec QK-G031, Instruction Manual

Page: 15 / 28

Quark-elec Manual
https://www.quark-elec.com 15 of 28 2018
V3
10.2.Relay wiring and temperature settings example
There are two ways to set temperature ranges using either the APP or GSM text commands. This
chapter provides examples for both methods.
APP Temperature Settings:
To use the APP to set temperature ranges; navigate to ‘OTHER’ in the bottom right hand corner of the
APP. There will be a sub heading marked for each relay and its corresponding temperature
sensor. Each relay and temperature sensor can have individual temperature ranges. See
example in next chapter.
Heating: For heating connect your equipment to the G031 in the Normal Open configuration as seen in
the table below.
In the Android APP, in the ‘OTHER’ section: set your temperature ranges to the relevant relays.
 Relay ON : the lowest heating activation temperature. (When colder than ‘xx‘, turn on.)
 Relay OFF : the highest heater operating temperature. (If warmer than ‘xx‘, turn off.)
(The ON temperature must be at least 1°C lower than the OFF temperature.)
Cooling: For cooling, reverse the way the relays are wired.
Connect your cooling equipment in the
Normal Closed
configuration as seen in the table below.
It is important to understand that relays wired in ‘normal closed’ position will operate in the
opposite way than expected. In this setup off will turn the relay on. This needs to be taken into
account during setup.
In the Android APP, in the ‘OTHER’ section: set your temperature ranges to the relevant relays.
 Relay OFF : the highest cooling activation temperature. (When warmer than ‘xx‘, turn on.)
 Relay ON : the lowest cooling operating temperature. (If colder than ‘xx‘, turn off.)
(The ON temperature must be at least 1°C lower than the OFF temperature.)
Example setting and wiring to maintain temperature at 25-40°C
Connected Device Heater Cooler
APP ON 25°C 35°C
APP OFF 30°C 40°C
Relay configuration
This is an example of a possible setup only. Your configuration will be different to the one shown.
SMS Temperature settings:
To use the text commands to set temperature ranges, you need to send a SMS command to the G031.
As above, the temperature settings correspond to a particular relay.
Set the temperature ranges by texting TEMPnxxxxtoxxxx#
 n=corresponding relay number
 xxxx=temperature using the or - XXX (X=single digit).
It should look something like ; +035. TEMP2-005to+035#
For more information about text commands see chapter command and response SMS list.