IS20 Manual
V 1.0
14 of 23
2023
Figure 12 IS20 WiFi working mode setting
To setup the IS20 to work in station mode, the followings need to be set up properly:
Mode:
set WiFi working mode to ‘Station’
SSID:
enter your wireless router’s SSID here.
Password:
enter y
our router’s password
IP:
enter an IP address here for your IP20 display. This has to be similar to the router’s IP
address, apart from the last number, which should be unique to the IS20 on the network. For
example, if your router’s IP address is 192.168.1.1, the IS20’s IP address should be 192.168.1.X,
where X is a number from 2 to 255. Please ensure this IP address is not being used by the router
or other devices on the network.
Gateway:
please enter the router’s IP address here.
Mask:
please enter the subnet mask here. Normally its 255.255.255.0
Below is a typical setup to a wireless router.
Figure 13 A typical WiFi setting
The IS20 can connect with most of Quark-elec WiFi products to display the data from them.
The following setting are for these products used the default settings.
