Quanum AQUAIOLIC, Assembly & Operation Manual

Page: 4 / 8

Circuit
&
Cooling svstem Diagram
CIRCUIT AND COOLING SYSTEM DIAGRAM IN THE BOAT
WATER
INLET
WATER PICKUP
RED
r=�
�o=
EE>
==
----��=���-;:-t----....J
8
60A ESC
BLACK BLACK
(w/BEC)
RECEIVER�
,-,
i.1:J
BATTERY PACK
SERVO
WATER OUTLET
l
P lease re f er to this diagram f or the water cooling system and wiring circuits.
Preparing Your Boat For Operation
Assembling the boat stand
Insert the 3 ABS pipes into the holes of the 2 stand ends as shown in
the diagram. P ush the ends and the ABS pipes tightly together. Stick
4 pieces of sticky back foam to the 4 angles where the hull will sit to
avoid scratches during construction and storage.
NOTE: AQUAHOLIC Deep Vee and RELENTLESS Catamaran
both use the same boat stand.
Installing the rudder and propeller
The rudder and the propeller re q uire installing to the boat. These are supplied in the parts bag
of the kit. Follow the steps as shown below to install them.
1.Remove the nut on the propeller shaft using a 7mm
spanner. Install the propeller and make sure the
dog drive lines up correctly then replace the nut and
tighten.
Rudder installation for A
q
uaholic Deep Vee.