Quanum AQUAIOLIC, Assembly & Operation Manual

Page: 5 / 8

2.lnsert the rudder support into the bracket which is pre-
installed onto the rear of the hull. Attach using the 2 x
M3 nuts and screws. Tighten the screws and nuts
using the 2.5mm allen key and a 5.5mm spanner.
3.Push the silicone tube water inlet pipe onto the brass
water inlet nipple.
Installing the Battery
i i
Aquaholic Deep Vee Relentless Catamaran
Caution: Before racing your
boat fit t he receiver inside the
balloon w hich is supplied in the
parts bag . Use a tie wrap around
t he end where the wires exit. For
a more permanent seal also use
some silicone sealer .
-
RECEIVER:
"'
llJ
4. Loosen the screw in the steering rod connector that is on
the steering arm with the 2.5mm allen key.
F eed the steering
rod through the hole, switch on the radio and center the servo,
center the rudder then re-tighten the screw.
Rudder installation Relentless Catamaran
Note: The rudder on the Relentless is mount on the right of the transom.
Install the rudder assembly in the same way as the
A
q uaholic using 2 x M3 nuts and screws. Connect the servo
rod in the same way making sure the servo and the rudder
are centered.
NOTE 1: We recommend you use a 11.1V 2200mAh 25C Lipo battery for maximum performance. Use
the s
upplied hook and loop tape (velcro) which are already installed to the battery tray inside the hull
t
o secure the battery. The battery tray is positioned to keep the center of gravity of the boat correct,
do not position the battery anywhere else inside the hull.
NOTE 2: T
here is a
w
ater proo
f
ru
bb
er seal in a slot
b
et
w
een the hatch an
d
the hull to
k
eep the ra
d
io
/
motor
compartment f ree o f w ater . Al w a y s ma k e sure it is securel y in place each time y ou f it the hatch .