iv
May 2004
001597-01 Rev. A09
•
Part 2 - Electrostatic Discharge (ESD) Requirements
•
Part 3 - Radiated Electromagnetic Field Requirements
•
Part 4 - Electrical Fast Transient/Burst (EFT) Requirements
•
Part 5 - Surge Requirements
•
Part 6 - Conducted disturbances, induced by radio-frequency fields Requirements
•
Part 8 - Power frequency magnetic field Requirements
•
Part 11 – Voltage dips, short interruptions and voltage variations Requirements
•
EN 55022:1998/(CISPR 22:1997), Class B, Limits and Methods of Measurement of Radio
Disturbance Characteristics of Information Technology Equipment.
The following standards apply only to the Desktop drive:
•
EN 61000-3-2: 1995, Limits for harmonic current emissions (equipment input) current up to and
including 16 A per phase
•
EN 61000-3-3: 1995, Limitation of voltage fluctuations and flicker in low-voltage supply systems
for equipment with rated current up to and including 16A.
FCC Notices (U.S. Only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
User Manual Notices for Class B Equipment
FCC Notices (U.S. Only)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more, of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio /TV technician for help.
Summary of Contents for ValueLoader DLT VS80
