7.0 Error Conditions and troubleshooting
Symptom
Solution
A flash cable is connected but
the output indicator is not lit or
blinking.
The cable could be broken,
shorted, or it may be the wrong
cable. Connect the cable to the
other output; if the output
indicator does not light, the
cable has one of the above
problems.
C type Flash Cable is connected
to a flash and the output light
blinks for 30 seconds
Turbo 3 has detected that no
flash is connected. This could
be caused by a bad cable or
loose cable. Check that the
cable is securely connected to
flash and battery, then restart
Turbo 3.
SD Camera Cable connected to
B socket, C Flash Cable to the A
socket. The A white flash LED
blinks and high voltage is shut
off.
Probably the “C” Flash Cable is
broken (the cable is faulty).
Replace the Flash Cable.
The green 25% fuel gauge LED
light blinks for a few minutes,
and then all lights go out and
there is no power to the
equipment connected.
This is the low battery indication.
Recharge. Check that the
charger is connected to a live
mains outlet that cannot be.
switched off.
8. Accessories for Turbo 3
All Flash Cables power flashes with Turbo 3, Turbo, Turbo 2x2, Turbo
SC, Turbo C, Turbo AC, Turbo Z,
Replacement Chargers:
Universal Charger TRU 100-240VAC, interchangeable mains plugs for
Euro, UK, US, Aust/NZ
Locking “C” type Flash Cables for flash power:
CKE2
Nikon*
CZ2 Canon*
CQ2
Qflash TRIO / PILOT
