Chapter 2 Installing Your Tape Drive
Managing the Tape Drive
SDLT 600A Product Manual
25
Telnet interface enabled
2
If you have a valid administrator password, checking this option will
allow you to access the management functions within the server using a
command-line (Telnet) interface.
Resetting System Defaults
2
As there is no access to the SDLT 600A other than the Ethernet port, a
mechanism has been implemented to reset the settings to their default
values. This is useful if an end user loses the IP address of the SDLT 600A.
The settings can all be set up through the Web manager (i.e. IP settings,
root password, ...).
To have the settings set back to their default values:
1
Switch off your SDLT 600A.
2
Disconnect the network cable from the drive.
3
Repeat the following procedure three times:
a
Insert a write protected cartridge into the drive.
b
Switch on the SDLT 600A.
c
After approximately one minute, the cartridge will be ejected.
d
Switch off the drive.
4
After the third ejection, connect your network cable and switch your
cartridge write protection on or off (as you need it), then reboot the
drive.
You can now set up the drive using the default IP address (10.10.10.10) as
the flash memory has been erased.
Changing the Management
Logon Password
2
In the
SDLT 600A main page
, you can access the
Change password
menu
(on the left side) to change the password of the
SDLT 600A management
page
.
Note:
In order to use this function at least one of the management
interface options must be enabled.
Note:
This is not the password for the FTP client user connection.
