6
Rack Mounting the Autoloader
SuperLoader™ 3 Quick Start Guide
Rack Mounting the Autoloader
This section provides the steps for attaching the autoloader directly to the stationary rails
of a rack. Refer to
table 1
for information on common rack hole types.
Table 1 Rack Hole Types
1
Install two clip nuts, 1.75 in. (44.45 mm) apart, onto each of the four rails of the rack,
making sure that you install each pair of clip nuts at exactly the same level (see
figure 2
).
Figure
Description
Square rack holes are the most
common type of rack holes.
They can accept either cage
nuts which mount from the back
of the rail or clip nuts which clip
on from the side of the rack rail.
Through holes require clip nuts
to accept mounting hardware.
Threaded holes require neither
cage or clip nuts to accept
mounting hardware.
Note:
The rails within the rack have a hole pattern that repeats throughout the rail.
Cage nut
Clip nut
Clip nut
