![background image](http://html1.mh-extra.com/html/quantum/qxs-12g-series/qxs-12g-series_site-planning-manual_3934021014.webp)
6
QXS 12G Site Planning Guide
Standard features of the cabinet include:
•
Front and rear door that can be closed and locked
•
Vertical rails, with mounting holes, to allow installation of storage
•
40U high cabinet and 19 inches/48.3cm wide
•
Four rolling coasters/wheels
•
Four leveling pads (bottom of cabinet)
•
A stabilizing foot (after installation of permanent location)
•
Access for storage cabling
•
AC or DC power source (2 each)
NOTE:
Install the applicable storage rack on the cabinet support rails, then install the
chassis/expansion storage unit, and then populate the unit with applicable drives (HDDs or SSDs).
Ensure to place the cabinet in a location that allows sufficient space to maintain and service (remove
and replace parts) the applicable units within the cabinet.
Cabinet Height
Cabinets heights might vary. A common cabinet is 40U high.
•
A height of 1U equals 1.75-inches (44.45-mm).
•
So, a 40U cabinet will have 70 inches (1778 mm/1.778 km) of storage space.
WARNING!
Risk of bodily harm and/or injury. Comply with the following:
•
Always populate the cabinet from bottom to top to prevent tipping.
•
If a cabinet must be moved, use adequate personnel and/or a forklift to relocate the cabinet.
• Push the cabinet from the front when moving.
• A fully populated cabinet can weigh almost 3000 pounds (1360.777kg).
• Cabinets are hard to move, even on a flat surface/floor.
•
If moving a cabinet on an incline, always remove the top-half storage arrays/devices to prevent
from tipping.