10
FastStor Rack Mount Installation Instructions
62-0125-01
3.
Grasp the handle and pull the drive assembly out from the chassis. There are two screws on the bottom of the drive assembly
frame that act like stops when removing the assembly. To slide the assembly past these stop points, simply lift up slightly on
the handle when the stops are encountered, and continue to pull the assembly out from the chassis. Set the drive assembly
aside.
4.
Place both FastStor units so that the right side of FastStor #1 is against the left side of FastStor #2 as shown in the following
illustration.
As shown, the two FastStor units are connected together at the rear with a single philips screw (#7) installed inside FastStor #2,
and at the front by a philips screw (#8) inside FastStor #2, used with a Kepnut (#9) inside FastStor #1.
FastStor # 1
FastStor # 2
5.
Open the front doors on both FastStor units.
6.
With your right hand, reach inside through the front opening of FastStor #2 and insert the philips, panhead screw through the
mounting hole located as shown in the illustration below. Continue to hold the screw in place
7.
With your left hand, reach inside through the front opening of FastStor #1 and install the Kepnut onto the philips screw. Use
a #1 Philips screwdriver to securely tighten the screw.
9
8
7
