ELM & ELM2 EMERGENCY LIGHTING UNIT RECALL INSPECTION & CIRCUIT BOARD REPLACEMENT INSTRUCTIONS | 7
The circuit board is held in place by two snaps,
one at each side of the circuit board. These
snaps must be flexed away from the circuit
board (as shown) while the board is pulled
gently and removed from the housing. It will
still be connected to the battery by the thicker
blue wire, which will be disconnected in the
next step.
BOTH ELM/ELM2 units: Disconnect the blue
battery connector at the circuit board located
at the BLUE BATT terminal. Use needle-nosed
pliers to unplug the battery terminal by
wiggling and gently pulling the terminal socket
from the terminal pin on the circuit board.
Leave the other wire(s) attached to the circuit
board in place.
ELM Units only: Now, using needle-nosed pliers
disconnect the blue and yellow lamp leads on
each side of the circuit board.
Remove the circuit board assembly:
Disconnect the blue battery wire connector:
D
E
