Quantum Dynamo ATS RevE/May03
www.pridemobility.com
31
ASSEMBLY
Figure 24. Connecting Front Frame Assembly
Figure 25. Fitting the Frames
Figure 26. Connect Battery Well Frame
LOCATING
PINS
CAUTION! Make certain that the front frame is snapped
securely to both the right frame assembly and to the
left frame assembly.
INSTALL THE BATTERY WELL FRAME.
1.
Hold the battery well frame so that the bottom of the well hangs
downward.
2.
Position the notches on the front of the battery well frame onto the
locating pins on the front frame bottom bar. See figure 26.
3.
Fit the notch on either side of the rear of the battery well frame onto
the locating pin on the power base frame assembly and onto the
locating pin on the other power base frame assembly.
4.
Make certain that the locking mechanisms snap securely into place.
INSTALL THE BATTERY BOXES.
1.
Place the front battery box into the front end of the battery well
frame.
NOTE: Make certain that the connectors are facing
toward the center.
2.
Place the rear battery box into the back end of the battery well
frame. Make certain that none of the wiring harnesses or cables
are pinched between the battery or the motor controller box and
the frame.
3.
Connect the battery boxes. Use the battery connection label for a
reference. See figure 4.
4.
Reconnect the left and right motor connectors. Be certain to match
the left connector to the left motor and the right connector to the
right motor. The connectors are labeled left and right. See figure 4.
INSTALL THE SEAT.
1.
Lift the Versa Seat directly up and position it over the power base
so that the seat posts line up with the seat mount connectors.
2.
Slide the seat posts down into the seat mount connectors.
3.
Align the locating holes in the seat posts with those in the seat
mount connectors, and insert the T-handle ball detent pins through
the holes.
INSTALL THE SWING-AWAY LEG RESTS.
1.
Press and hold the locking lever, and slide the swing-away leg rest
into the mounting bracket.
2.
Swing the leg rest to the center position.
3.
Release the locking lever to lock the leg rest in place.
4.
Repeat steps 1 through 3 for the opposite leg rest.
CONNECT THE JOYSTICK/CONTROLLER.
1.
Reconnect the joystick/controller harness to its connector on the
electronics tray. See figure 3.
CAUTION! Do not place the joystick/controller harness
so that it can be pinched in the seat frame or the power
base frame.
Summary of Contents for Dynamo ATS
Page 39: ......
