30
www.pridemobility.com
Quantum Dynamo ATS RevE/May03
Figure 23. Frame Assemblies
REMOVE THE BATTERY WELL FRAME.
1.
Disconnect both battery connectors and both motor connectors.
See figure 4.
2.
Lift and remove each battery box. See figure 20.
3.
Squeeze together the latch release levers that hang vertically down
from the crossbar at the rear of the battery well frame. Lift up the
rear end of the battery well frame. See figure 21. Pull it to the rear
of the chair to release the front slots from the locating pins on the
front frame bottom bar.
DISASSEMBLE THE RIGHT AND LEFT POWER BASE FRAME
ASSEMBLIES.
1.
Stand behind your power chair and grasp one of the power base
frame assembly handles.
2.
Press the chrome latch release lever toward the center of the frame
and hold it. See figure 22.
3.
Push the frame assembly outward and pull up on the front frame
until the latching mechanism releases.
4.
Keep pulling upward until the locating pin on the bottom of that side
of the front frame releases from its slot in the power base frame
assembly.
5.
Carefully let the power base frame assembly tilt to a resting position.
6.
Repeat for the other power base frame assembly.
Figure 20. Removing Battery Boxes
Figure 22. Removing Front Frame
Figure 21. Removing Battery Well
ASSEMBLY
A
SSEMBLY
FRONT FRAME AND POWER BASE FRAME ASSEMBLY
1.
Place the three frame assemblies next to each other as shown in
figure 23.
2.
Grasp the front frame and fit the notch on the front frame bottom
bar onto the locating pin on the lower section of the power base
frame assembly. See figure 24.
CAUTION! The front frame should be positioned with the
two semicircular notches in the vertical bar facing forward.
3.
Pivot the front frame top bar toward the power base frame assembly
and push the front frame top bar onto the locking mechanism until
the two assemblies snap securely into place. See figure 25.
4.
Repeat for the other power base frame asssembly.
Summary of Contents for Dynamo ATS
Page 39: ......
