20
www.pridemobility.com
Quantum 1650/RevA/Jan04
I V . A S S E M B L Y
SEAT INSTALLATION
The Quantum 1650 seat is attached to the power base by four seat pins. Each pin is inserted into a receiver on the power
base frame. The seat pins have holes that enable you to adjust the seat height. Ball detent pins are inserted through the
receiver and through the seat pins to secure the seat
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose
control of the seat if they do so, resulting in personal injury or damage to the chair.
To install the seat:
1. Lift the seat over the power base.
2. Align each seat pin with the corresponding receiver. See figure 9.
3. Gently allow the seat to slide into each receiver until the seat is at the desired height.
4. Insert the ball detent pins into each receiver.
5. Install the armrests (if necessary). See figure 10.
6. Loosen the setscrews on the controller mount. See figure 13.
7. Slide the controller into the armrest.
8. Tighten the setscrews to secure the controller.
9. Use a wire tie to secure the controller cable to the armrest.
10. Plug the communications cable into the back of the Remote Plus and into the connector on the power base. See figure 6 and 17.
Figure 9. Seat Installation/Removal (typical)
SEAT PIN
SEAT
RECEIVER
POWER BASE
BALL DETENT PIN
CONTROLLER
MOUNT