11
5. Fire Qflash. Push the the
Option
n
button, until the compensation dis
play appears.
6. Use the
Set
u
and
Up
J
button to increase light output (if flash meter
reads less than F 8.0), or the
Down
L
button to decrease light output
(if flash meter reads more than F 8.0). The light output can be increased
or decreased by as much as 2 stops in 1/3 steps.
8.3 Option Menu 3
FW7Q Zone Control
This option menu is only available when a FW7Q is attached to the Qflash.
With this option menu you can access the zone and the range settings of
the FW7Q.
You can enter this menu by pushing the
Option
n
button until it shows up
on the Qflash’s display. The
Set
u
button will cycle through the available
settings. Use the
Up
J
/
Down
L
buttons to make a change.
8.4 Restoring Factory settings
Qflash options and settings are preset at the factory. You can restore the
factory settings by the following method:
1. Turn Turbo or Qpaq OFF. Connect Qflash to Turbo or Qpaq.
2. Press and hold any button (except
Test
M
).
3. Turn Turbo or Qpaq ON.
4. The Qflash will display a reset message.
5. Press
Mode
I
to reset the Qflash and restore the factory settings.
If you push any other button or fail to push the
Mode
I
button within 4 sec-
onds, the Factory settings will not be restored.
QFT5D P635A 1.11_QFT5D P635A 1/11/12 1:51 PM Page 15
