7.15 Drive Bay PCBA
2–Drive P/N 501326-01-1
4–Drive P/N 501336-01-0
6–Drive P/N 501357-01-1
Tools Required:
•
Flat-blade Screwdriver
•
Number 2 Phillips Screwdriver
•
1/4-inch Hex Nutdriver
7.15.1 Drive Bay PCBA Removal
1.
Turn off the TLS power and remove the power cord.
2.
Remove the Top Panel (Section 7.4.1).
3.
Remove the left Side Panel, as seen from the front of the TLS (Section 7.4.3).
4.
Use a flat-blade screwdriver to turn both 1/4-turn fasteners at the top of the
Drive Access Hatch counter-clockwise, then open the hatch (Figure 7-33).
1/4 turn Fasteners (2)
1/4 turn Fasteners (2)
Drive Access Hatch
Drive Access Hatch
42xx Series
44xx Series
46xx Series
Figure 7-33 TLS Rear Views
5.
Disconnect all the cables from the Drive Bay PCBA (Figure 7-34).
501380 Rev. B
Field–Replaceable Units (FRUs)
7-53