Quadro SSC-5031-15, Operating And Installation Instructions

Page: 68 / 72

Part 5 : CLEANING AND MAINTENANCE OF YOUR OVEN
CLEANING
Be sure that all control switches are off and your appliance cooled before cleaning your oven. Plug
off the appliance. Check whether they are appropriate and recommended by the manufacturer before
using the cleaning materials on your oven. As they may damage the surfaces, do not use caustic
creams, abrasive cleaning powders, thick wire wool or hard tools. In case the liquids that overflow
around your oven burn, the enameled parts may be damaged. Immediately clean the overflown
liquids.
Cleaning of Inside of Your Oven
Surely plug off the oven before starting cleaning. The inside of enameled oven is cleaned in the
best way when the oven is warm. Wipe the oven with a soft cloth that had been soaked in soapy water
after each use. Later wipe it with a wet cloth once more and then dry it. It may be required to use a
liquid cleaning material from time to time and make a complete cleaning. Do not clean with dry/powder
cleaners or steam cleaners.
Cleaning of Your Oven Cover
In order to be able to clean the cover of your oven from inside and outside, use a glass cleaner. Then
rinse, dry it with a dry cloth.
Cleaning of Gas Cooker - Hob Part
Lift up the saucepan supports, caps and crowns of hob burners. Wipe and clean the back panel with a
soapy cloth. Wash the caps and crowns of hob burners and rinse them. Do not leave them wet,
immediately dry them with paper cloth. After cleaning, make sure that you re-assemble the parts correctly.
Do not clean any part of the hob with metal sponge. It causes the surface be scratched. The pan support
top surfaces may be scratched in time due to usage. These parts will not get rusted and it is not a
production fault. During cleaning of the hob plate, make sure that no water flows inside the burner cups, as
this may block the injectors.
Burner Caps:
Periodically, enameled pan support, enameled covers, burner heads must be washed with soapy
warm water rinsed and dried. After drying them thoroughly, replace them correctly.
Enamelled Parts :
In order to keep them a new, it is necessary to clean them frequently with mild warm soapy water and
then dry with cloth. Do not wash them while hot and never use abrasive powders or abrasive cleaning
materials. Do not leave vinegar, coffee, milk, salt, water, lemon, or tomato juice to remain in contact with
enameled parts for long periods of time.
Stainless Steel:
Stainless steel parts must be cleaned frequently with mildly warm soapy water and a soft sponge
and then dry with a soft cloth. Do not use abrasive powders or abrasive cleaning metarials. Do not
leave vinegar, coffee, milk, salt, water, lemon or tomato juice to remain in contact with stainless steel
parts long periods of time.
2
5