Make sure the front seal is snug against the
windshield seal as shown in FIG 2
4
. The “C”
should fit in the cutout of the roll bar pad.
Line up the threads in the “C” with the top hole in
the roll bar.
Repeat this procedure on the passenger side.
5
FIG 23
FIG 27
Secure Front Door Surrounds to Roll Bar
Locate the two sets of screw knobs in each Door surround
box. There should be (2) sets of two knobs. Line up the door surround “C” attachment holes with the
vertical holes in the roll bar. Slip the front knob through the hole in the front door surround (FIG25).
Tighten the knob securing the front door surround FIG 26. Repeat this procedure on the
rear
door
surround
hole
and on the other side of the vehicle. Finally, tighten all four knobs. All knobs on both sides
of the vehicle should be secured to the roll bar. This completes the installation of the door surrounds to
your vehicle.
Step 4: Install
ing the
Center Bow to the Vehicle
Locate the center bow assembly
as shown in F
ig 27
below
.
FIG 20
FIG 21
FIG 22
FIG 24
Next, Insert this pin into the body tub as shown in FIGs 20 & 21. After inserting the pin, locate the upper
portion of the door surround “C” attachment and push onto roll bar (FIGs 22& 23).
Install Door Surrounds to Jeep: Continued
FIG 2
5
FIG 2
6
