Step 2: Install Bow Mount Brackets to Roll Bar
Locate the (2) bow mounting brackets and
(4) Allen head pivot bracket bolts shown in FIG 8. Carefully unzip the roll bar padding on the
vertical side tube to expose the two factory holes in the roll bar. With a razor knife, trim the
hard foam where the top of the bracket will sit (FIG 9).Locate the bow mounting brackets over
the factory holes and using the Allen head pivot bracket bolts, install brackets to the roll bar
(FIG’s10 & 11). Slip the roll bar padding back over the installed brackets carefully slipping the
bracket mounts through the slits in the roll bar padding. Repeat on passenger side.
3
Next, secure the over door bow to the Header leg with the attached set screw (Fig 6).Slide
the bow sleeve over the knuckles as shown in Fig 7. Repeat this procedure on the opposite
side.
FIG 8
FIG 9
FIG 10
FIG 11
