Important Safety information
Your QuadraTop®
Adventure Top
is
intended to be used with other QuadraTop
Products to increase the fair weather enjoy-
ment of your off-road capable vehicle.
Before
installation,
please take a moment to review the following
safety information and installation instructions.
Important safety information is generally prece
-
ded by one of three signal words indicating the
relative risk of injury.
The signal words mean.
a hazardous situation which, if not avoided, could result in death or serious in-
jury. You CAN be KILLED or SERIOUSLY HURT if you don’t follow instructions.
WARNING
CAUTION
NOTICE
a hazardous situation which, if not avoided, could result in minor or moderate
injury. You CAN be moderately HURT and also may suffer property damage if
you don’t follow instructions.
Careful attention is required to this instruction or operation but does genera-
lly not relate to personal injury. Damage to your Quadratec® product or other
property may result if you don’t follow instructions.
Before you begin Installation:
We are excited that you have chosen the Adventure Top. This high-quality soft top is designed to provide
protection from the elements and a stylish look on your Jeep®. Please note that it is important that you
become familiar with the installation process of this top by reading the following instruction sheet and
warnings thoroughly. When unpacking, carefully check to make sure all parts are included. If any part is
missing or broken, please call Quadratec customer service at 800-745-6037.
For a smooth fit and ease of installation, this top should be installed at tempe
-
ratures above 72 degrees. Below this temperature, the fabric may contract an
inch or more making it difficult to install. We highly recommend taking the top
out of the package and letting it sit inside a warm place or direct sunlight for
1-2 hours before you install the top. When warm, this top will install quickly.
NOTICE
2
Step 1: Install Over Door Bows to Front Header Assembly
Locate the Fabric/Header assembly and the two over door bows as shown in Figs 1 & 2 and
place the assembly on a table top or on a soft towel with the underside facing up and the two
“header legs” facing away from the header.
Locate the over door bow assembly (Fig 3) and round bow/header sleeve (round tube).Slip
the round door “sleeve” over the header leg and insert the “knuckle” installed on the over door
bow into the Header leg (Fig 4) making sure the quick release knuckle is facing outward (Fig
5).Note that the over door bow assembly are sided: left and right.
FIG 1
FIG 2
