background image

The Trusted Source

®

2

READ ALL SAFETY MESSAGES AND ALWAYS WEAR
SAFETY GLASSES WHEN WORKING WITH TOOLS.

a hazardous situation which, if not avoided, could result in death or
serious injury. You CAN be KILLED or SERIOUSLY HURT if you don’t
follow instructions.

a hazardous situation which, if not avoided, could result in minor or
moderate injury. You CAN be moderately HURT and also may suffer
property damage if you don’t follow instructions. 

Careful attention is required to this instruction or operation but does
generally not relate to personal injury. Damage to your Quadratec

®

product or other property may result if you don’t follow instructions. 

A Few Words About Product Safety: 

Your Quadratec

®

QRC Rear Bumper is

intended to enhance the utility and
enjoyment of your off road capable
vehicle. Before installation, please
review the following safety information
and installation recommendations.

Throughout these instructions impor-
tant safety information is generally
preceded by one of three signal words
indicating the relative risk of injury,
property damage or adverse conse-
quence. The signal words mean:

Before You Begin Installation: 

Congratulations on your purchase of
Quadratec

®

QRC Rear Bumper for your

Jeep

®  

Wrangler. This custom fit Bumper

has been designed for long life and a
great look. Though constructed of only
the finest materials, this bumper must
be maintained to keep its look while per-
forming under the toughest conditions.
Please see page 7 for important care and
maintenance tips to keep your bumper 

looking like new. When unpacking,
check to make sure all parts are in-
cluded and not damaged due to ship-
ping. If any part is missing or broken,
please call Customer Service at
800-745-6037 as soon as possible.

Thank you again for your purchase
and let’s start the installation process.

AS YOU UNPACK YOUR REAR BUMPER, BE CAREFUL NOT TO SCRATCH
THE FINISH WITH A KNIFE OR RAZOR. WE SUGGEST PLACING THE
UNPACKED BUMPER BACK INTO THE ORIGINAL BOX SO IT DOES NOT
GET SCRATCHED BEFORE THE INSTALLATION BEGINS. 

ACCESSORY REAR BUMPERS ARE HEAVY AND WE STRONGLY
SUGGEST THE ASSISTANCE OF AN ABLE-BODIED ASSISTANT DURING
LIFTING AND INSTALLATION OF YOUR BUMPER.

QRC_JK_REAR_12057_0220_A4.qxp_A4  6/26/17  10:14 AM  Page 2

06262017101613

Summary of Contents for QRC JK









Reviews: