R
January 21, 2013
7019-221D
Page 37
Santa Fe Pellet Insert
Brick is flush against back wall
Notches
exposed
Re-installing Baffle & Brick Set
1. Place right brick in behind the right bracket, and then
slide to the left so the tabs are behind the center brick.
Figure 37.4.
2.
The brick will be flush against the back wall and notches
exposed in the side bracket.
Figure 37.5.
3. Lift slightly and pull the right edge of the brick forward until
it stops and then drops down into both top and bottom
notches of right bracket and locks into place.
Figures
37.1 and 37.2.
4. Repeat for left brick.
5.
Insert baffle into top front inside the firebox and pull for
-
ward. Then raise up the bottom end and insert baffle tab
into slot on the top of the right bracket to lock into place.
Figure 37.3.
Place the left side hook at the bottom of the
baffle over the top edge of brick for stability.
Figure 37.4.
6.
The baffle does not completely cover the top of the firebox.
There is an opening on the left as shown in
Figure 37.5.
Tabs
Figure 37.4
Figure 37.5
H. Baffle & Brick Set Removal
1. Follow proper shutdown procedures in Section 10.
2. The top baffle has a hook on the bottom left side that
rests on the top lip of the cast brick. There is a tab on
the bottom right side that hooks into the side bracket.
Remove the top baffle by first pulling the baffle forward
until back edge drops down. Then slide baffle back until
the front edge clears the shelf that it had been resting on.
Figure 37.1.
3
. The top baffle must be removed before you can remove
the right and left brick. Remove the right brick by hold-
ing top lip of brick and lifting up, then push outside edge
back. Slide brick to the right until it is flush with the firebox.
Rotate the inside edge of the brick forward and remove
brick. Repeat for left brick.
Figure 37.2.
Remove Right
& Left Brick
Hook on
left side
Tab on
right side
Vacuum
Exhaust Area
Right Brick
Removed
Figure 37.1
Figure 37.2
Figure 37.3
