22
7050-146A
6/27/2014
SANTA FE FREESTANDING
D. Baffl e & Brick Set Removal
1. Follow proper shutdown procedures in Section 10.
2. The top baffl e has a hook on the bottom left side that
rests on the top lip of the cast brick. There is a tab on
the bottom right side that hooks into the side bracket.
Remove the top baffl e by fi rst pulling the baffl e forward
until back edge drops down. Then slide baffl e back until
the front edge clears the shelf that it had been resting on.
Figure 22.1.
3. The top baffl e must be removed before you can remove
the right and left brick. Remove the right brick by hold-
ing top lip of brick and lifting up, then push outside edge
back. Slide brick to the right until it is fl ush with the fi rebox.
Rotate the inside edge of the brick forward and remove
brick. Repeat for left brick.
Figure 22.2.
Remove Right
& Left Brick
Hook on
left side
Tab on
right side
Vacuum
Exhaust Area
Right Brick
Removed
Figure 22.1
Figure 22.2
Figure 22.3
E. Baffl e & Brick Replacement
1. Place right brick in behind the right bracket and then slide
to the left so the tabs are behind the center brick.
Figure
22.4.
2. The brick will be fl ush against the back wall and the
bracket’s notches will be exposed.
Figure 22.5.
3. Pull the right edge of the brick forward and slide the brick
into the notches both top and bottom of right bracket.
Figure 23.1.
4. Repeat for left brick.
5. Insert baffl e into top front of fi rebox and then raise up the
bottom end and insert baffl e tab into notch on the right
bracket to lock into place.
Figure 23.2.
Place the left
side hook of the bottom baffl e over the top of brick for
stability.
6. The baffl e does not completely cover the top of the fi re-
box. There is an opening as shown in
Figure 23.3.
Brick is flush against back wall
Brick in
front of
clip and
Notches
exposed
Tabs
Do not remove rope
from center brick
Figure 22.4
Figure 22.5
