21
17 August, 2018
7075-177A
VOYAGEUR GRAND AU
G. Standard Surround & Cast Trim Kit
Standard Size: 184.15cm W x 76.2cm H
Large Size: 121.92cm W x 34 86.36cm H
Included in Surround Kit:
(2) side pieces, left and right;
(1) l top piece; (1) fastener package; (1) heat deflector.
Included in Cast Trim Kit:
(2) cast trim legs, left and right;
(1) cast trim header; (2) cast trim footers, left and right; (1)
fastener package.
Tools Needed:
Powered 4 to 6 inches long Phillips head
screw driver; pliers
1.
Remove contents from box being careful not to scratch
or damage the cast trim pieces.
2. Lay surround face down on a protected surface to
prevent scratching.
3. Using a 4 to 6 inches long Phillips head screw driver
attach the side surrounds to the top surround using (2)
#8 sheet metal screws on each side provided with the
kit
4.
Place the peel and stick round felt vibration insulation
pads on the front side in each corner of the top metal
piece and on the back side in each corner of the top
cast piece (
Figure 21.1).
5. Place the corresponding cast trim pieces (2 cast trim
sides and 1 cast trim header) underneath the panel
set, also face down. Align the holes in the metal pieces
with the 5 bosses on the top cast piece and 2 bosses
on each side piece.
6.
Secure the magnet to the bracket and attach the
magnet and bracket to each metal side piece at the
bottom. The magnet is facing the front (
Figure 21.2).
7. Place the cast footers under the metal sides aligning
the top and bottom holes in the cast footers and metal
sides.
8. The 9 mounting clips are shipped in one long strip.
Hand break apart or use pliers.
9. Each clip has a clearance notch to allow room for the
cast on the insert. Place the clip so the notch is facing
the outer edges of the surrounds (
Figure 21.3).
10.
It is best to install all of the 1/4-20 screws only half
way at first to allow for adjustments. After adjustment,
tighten the 2 screws in each cast footer first and then
work your way around to the rest.
11. Slide surround and trim over the top of the insert into
place matching the mounting tabs on the metal sides
with the slots on the insert
(Figure 21.4)
.
12. Align the 2 screws in the top metal surround piece to
the 2 alignment holes on the appliance top. Secure in
place (
Figure 21.4).
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Cast Footers,
Left & Right
Figure 21.1
Back
of
Side
Piece
Magnet Attached - Faces Front
Clearance Notch
Figure 21.2
Figure 21.3
Match Mounting
Tabs to Slots on
the appliance
Figure 21.4
