July 7, 2015
7022-514C
3
CASTILE INSERT
Model
Castile Pellet Insert-B
Laboratory
OMNI Test Laboratories, Inc.
Report No.
061-S-77d-6.2
Type
Solid Fuel Room Heater/Pellet Fuel
Burning Type Insert
Standard
ASTM E1509-2004, ULC S628-93 and
ULC/ORD-C1482-M1990 Room Heater
Pellet Fuel Burning Type and (UM) 84-
HUD, Mobile Home Approved
FCC
Complies with Part 15 of FCC Rules.
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
1
Important Safety Information
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifi cations and/or price without notice.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
• Installation and use of any damaged appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with unit).
• Do NOT Overfi re - If appliance or chimney connector glows,
you are overfi ring.
Any such action that may cause a fi re hazard.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided
by, the following actions:
C. Glass Specifi cations
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
D. Electrical Rating
115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps
NOTE:
Some generator or battery back-up systems may
not be compatible with the micro-processor electronics on
this appliance. Please consult the power supply manufac-
turer for compatible systems.
E. Mobile Home Approved
•
This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
•
The structural integrity of the mobile home fl oor, ceil-
ing, and walls must be maintained.
•
The appliance must be properly grounded to the frame
of the mobile home and use only Listed pellet vent
Class “L” or “PL” connector pipe.
•
Outside Air Kit, part OAK-ACC must be installed in a
mobile home installation.
NOTE:
This installation must conform with local codes. In
the absence of local codes you must comply with the
ASTM
E1509-2004, ULC S628-93, ULC/ORD-C-1482-M1990,
(UM) 84-HUD
A. Appliance Certifi cation
B. BTU & Effi ciency Specifi cations
The Quadra-Fire Castile Pellet Insert meets the U.S. Environ-
mental Protection Agency’s emission limits for pellet heaters
sold after May 15, 2015.
This pellet insert needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this pellet insert in a manner inconsistent with operating
instructions in this manual.
EPA Certifi cation #: 940-14
EPA Certifi ed Emissions: 1.8 grams per hour
*LHV Tested Effi ciency: N/A
**HHV Tested Effi ciency: N/A
***EPA BTU Output: 8,500 to 28,200 / hr.
****BTU Input: 11,600 to 38,700 / hr.
Vent Size: 3 or 4 inches, “L” or “PL”
Hopper Capacity: 45 lbs.
Fuel Wood Pellets
* Weighted average LHV effi ciency using data collected during
EPA emissions test.
**
Weighted average HHV effi ciency using data collected during
EPA emissions test.
***
A range of BTU outputs based on EPA Default Effi ciency and
the burn rates from the low and high EPA tests.
****
Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU’s which is the average BTU’s from a
pound of pellets.
