29
February 5, 2019
7022-515I
CASTILE INSERT
D. Igniter Replacement
1. Shut down the appliance by turning down the
thermostat
and let the appliance completely cool down
.
After the appliance has cooled down, unplug it and
remove the ash drawer.
2. The wire leads to the igniter are connected to the wire
harness with 1/4 inch (6mm) male / female spade
connectors. These wires will pull forward approximately
4 to 5 inches (102mm to 127mm) through the grommet
at the back of the ash drawer chamber. Disconnect the
spade connections and remove the igniter from the
chamber. Loose the thumb screw and slide igniter out.
3. Install new igniter into the chamber and tighten the
thumb screw. Re-connect the wires to the 2 leads with
the spade connectors.
4.
Push excess wire leads back through the grommet, one
wire at a time, to take-up the 4 to 5 inches (102mm to
107mm) previously pulled out. This will keep the wires
out of the way of the ash drawer. Double check that
the igniter wires are clear of any movement, i.e. ash
drawer, fire pot cleaning rod, cleaning slide plates, etc.
5. Re-install the ash drawer and then re-install the side
panel and re-connect the power.
E. Glass Replacement
1.
Open the face and remove door from the appliance by
lifting door off of hinge pin and lay on a flat surface face
down.
2.
Using a screwdriver, tap the bottom of the rope retainer
rod to push it up out of the hole. The top end of the rod
will slide up. Swing the rod toward you from the bottom
and remove the rod. Repeat for other side.
3. Remove old glass and replace with new glass.
4.
Slide the retainer rod into the top hole first, and then
line up the bottom crimped end with the hole in the
door. The crimped end must be parallel with the glass
in order to insert it into place (
Figure 29.2).
Figure 29.1
Figure 29.2
Igniter
Igniter Bracket
Thumb Screw
Slide this
end in first
Rope Retainer Rods
Glass ships
with Gasket
Installed
Crimped end must
be paralle with the
glass
Gasket
•
Glass is 5mm thick high temperature
heat-resistant ceramic glass.
•
DO NOT REPLACE with any other
material.
• Alternate material may shatter and
cause injury.
WARNING