BODEGA BAY WOOD INSERT
Page 14
August 20, 2008
R
435-1320B
BLOWER CORD LOCATION
Remove Bolt
Remove Bolt
Figure 14A
Figure 14C
Figure 14D
Figure 14B - Right Side Location
Black
Red
White
Snap Disc
Blower Control
Box with Switch
Cooling Fan
Black
Operating the Blower Control Box with Switch
1. The blower will turn on/off automatically when set to AUTO.
2. When set to MANUAL, the fan will turn on/off only when you
turn it on or off. This setting over-rides the internal snap
disc.
3. Adjust the speed of the fan by turning the HIGH/LOW knob
to the desired setting.
Black
Red
White
Snap Disc
Cooling Fan
Figure 14C - Left Side Location
BLOWER CORD LOCATION & BLOWER
CONTROL BOX WITH SWITCH
This insert comes standard with a blower, installed at the
factory with blower cord on right side of insert (as you face
the unit). The blower cord can also be installed on the left
side. Disconnect the cord from right side.
ROUTE WIRES IN
FRONT OF FAN
.
Re-install on the left side. Do not route cord
behind the cooling fan.
FAN (BLOWER) REPLACEMENT
Included in Kit:
Replacement Blower
Tools Needed
: 5-32 Wrench and Phillips Head Screwdriver.
1. Remove bolts from both sides of the insert and slide the
lower cover towards you.
See Figure 14D
2. Remove 6 that secures motor to the housing. Remove
the motor.
See Figure 14E.
3. Attach new motor using the same screws to the blower
housing.
4. Re-attach lower cover to insert using the bolts removed
in Step 1.
HIGH OFF
LOW
FAN
AUTO
MANUAL
MANUAL: Over-rides
the internal Snap Disc
AUTO: Fan will
turn ON/OFF
automatically and
is controlled by the
internal Snap Disc
Figure 14E
