Unplug wire
harness before
removing fan
Remove
nut and lift
out fan
• Removing the fan
- Unplug the wire harness.
- Lift fan from locating pins and remove (Figure 4.9).
Repeat for second fan if necessary.
- Connect new fan wires to wire harness.
- Before installing the fan, make sure the grommets
are tightly in place. Insert the right fan and place
over the two locating pins. Repeat for other fan.
Figure 4.10
- Re-install bottom panel or firebox access panel
in reverse order as described above.
-
Replace the brick that was removed.
- Re-install the fascia and both knobs.
- Re-install both doors and hinge pins.
- Reconnect the power.
Figure 4.9 Fan Motor
Figure 4.10 Installing Fans
Remove 2 screws and
pry open access door.
• Remove both doors, outside air knobs, fascia, and
brick.
• Remove two Phillips head screws and pry open
access door in the bottom of the fireplace with a flat
head screwdriver. See Figure 4.11.
• Remove two screws and take off access cover shown
in Figure 4.12.
NOTICE:
The timer assembly included in this kit comes
with the air chamber cover attached (Figure 4.13).
• You will need to disconnect air chamber cover from
timer assembly before installing in the fireplace. Set
screws aside for later use. See Figure 4.14 .
Figure 4.11 Open Access Door
Figure 4.12 Access Cover
Air Chamber Cover is
attached to Timer Assembly
Figure 4.13 Timer Assembly with Air Chamber Cover
(Linkage arm is not included in the kit)
6. Timer Assembly Replacement
CAUTION!
Risk of Shock! Disconnect power by
turning off circuit breaker BEFORE servicing.
22
Quadra-Fire • 7100 FP Owner’s Manual • 433-3600 • Rev J • 09/21/15
