August 3, 2015
7038-206E
3
5700 STEP TOP
Model:
5700 Step Top Uni-Body (ACC)
Laboratory:
OMNI Test Laboratories, Inc.
Report No:
061-S-73-6.2
Type:
Listed Room Heater, Solid Fuel Type
Standard:
UL1482-96 and ULC S627-00 and (UM)
84-HUD, Mobile Home Approved.
EPA Certifi cation #: 714
EPA Certifi ed Emissions: 2.3 grams per hour
*LHV Tested Effi ciency: 77.9 %
**HHV Tested Effi ciency: 72.1 %
***EPA BTU Output: 11,100 to 40,400 / hr.
****Peak BTU/Hour Output: 76,200
Vent Size: 6 inches
Firebox Size: 2.98 cubic feet
Recommended Wood Length: 22 inches
Fuel Orientation: Front-to-Back
Fuel Seasoned Cord Wood
* Weighted average LHV effi ciency using Douglas Fir dimension-
al lumber and data collected during EPA emissions test.
**
Weighted average HHV effi ciency using Douglas Fir dimen-
sional lumber and data collected during EPA emissions test.
***
A range of BTU outputs based on EPA Default Effi ciency and
the burn rates from the low and high EPA tests, using Douglas
Fir dimensional lumber.
****
A peak BTU out of the unit calculated using the maximum fi rst
hour burn rate from the High EPA Test and the BTU content of
cordwood (8600) times the effi ciency.
The Quadra-Fire 5700 Series Wood Stove (ACC) meets the
U.S. Environmental Protection Agency’s crib wood emission
limits for wood heaters sold after May 15, 2015.
This wood heater needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this wood heater in a manner inconsistent with operating
instructions in this manual.
1
Important Safety Information
A. Appliance Certifi cation
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifi cations and/or price without notice.
C. Mobile Home Approved
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is provided. The structural integrity of
the mobile home fl oor, ceiling, and walls must be maintained.
The appliance must be properly grounded to the frame of the
mobile home and use only listed double-wall connector pipe.
Outside Air Kit, part OAK-ACC must be installed in a mobile
home installation.
D. Glass Specifi cations
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
•
Installation and use of any damaged appliance.
•
Modifi cation of the appliance.
•
Installation other than as instructed by Hearth & Home
Technologies.
•
Installation and/or use of any component part not approved
by Hearth & Home Technologies.
•
Operating appliance without fully assembling all
components.
•
Operating appliance without legs attached (if supplied with
it).
•
Do NOT Overfi re - If appliance or chimney connector glows,
you are overfi ring.
Any such action that may cause a fi re hazard.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided
by, the following actions:
B. BTU & Effi ciency Specifi cations
Hearth & Home Technologies WILL NOT warranty stoves
that exhibit evidence of over-fi ring. Evidence of over-fi ring
includes, but is not limited to:
• Warped air tube
• Deteriorated refractory brick retainers
• Deteriorated
baffl e and other interior components
E. Non-Combustible Materials
Material which will not ignite and burn, composed of any
combination of the following:
-
Steel
-
Plaster
-
Brick
-
Iron
-
Concrete
-
Tile
-
Glass
-
Slate
Materials reported as passing
ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace of 750° C.
F. Combustible Materials
Material made of/or surfaced with any of the following ma-
terials:
-
Wood
-
Compressed
Paper
- Plant Fibers
- Plastic
- Plywood/OSB
- Sheet Rock (drywall)
Any material that can ignite and burn: fl ame proofed or not,
plastered or un-plastered.
NOTE:
This installation must conform with local codes. In the
absence of local codes you must comply with the
UL1482, (UM)
84-HUD and NPFA211
in the U.S.A. and the
ULC S627-00 and
CAN/CSA-B365 Installation Codes
in Canada.
