MANUAL:
Press and release for fog on demand
The menu options displayed on the wired remote are as follows:
Function
Selection
Content
Heating status
Warming Up
Ready to Work
Unit warming up please wait
Unit is ready to use
Bubble control
Bubble ON
Bubble OFF
Bubble flow on
Bubble flow off
Interval
Set 1-200
Set interval of fog time
Duration
Set 1-200
Set continuous fog duration
DMX512
Add 1-512
Set DMX address
Volume
Set 0-100
Set fog output volume (low to high)
Red
Set 0-100
Set Red LED Light effect (dark to bright)
Green
Set 0-100
Set Green LED Light effect (dark to bright)
Blue
Set 0-100
Set Blue LED Light effect (dark to bright)
Glint
Set 0-100
Set LED strobe effect (slow to fast)
Skip
Set 0-100
Set LED colour change (slow to fast)
Gradual
Set 0-100
Set LED colour fade (slow to fast)
Operation: Wireless remote
The small RF remote control supplied can also be used when wireless control of the unit is
needed. Ensure the wired remote control is connected to the unit, to use the RF remote for
the following functions:
1
: Press for fog effect on/off
2
: Press for bubbles on/off
3
: Press for LED colour range/off
4
: Press for LED colour change/fade/off
Operation: DMX Control
For DMX control, connect a signal source to the DMX input on the unit via a balanced XLR
lead. Extra units can also be controlled with the same DMX signal by looping through the DMX
out on the unit. Set the unit to DMX512 mode and confirm the correct start address, then use
the table below for channel selection.
