Channel
Value
Content
CH1
0-255
Fog effect (low to high)
CH2
0-255
Bubble effect (low to high)
CH3
0-255
Bubble height and fan speed increase
CH4
0-255
Bubble volume and fan speed increase
CH5
0-255
Red LED (low to high)
CH6
0-255
Green LED (low to high)
CH7
0-255
Blue LED (low to high)
CH8
0-255
Strobe effect (slow to fast)
CH9
0-130
Colour change mode
131-255 Colour fade mode
CH10
0-255
Colour change/fade mode speed adjust (slow to
fast)
Specifications:
Power supply
220-240Vac, 50/60Hz (IEC)
Fuse rating
F5A
Power
900W
DMX channels
10CH
Warm up time
3-5 minutes
Remote control frequency
433Mhz
Fog output (approx.)
5,000 cu.ft per minute
Tank capacity
1.2 litres (fog)
Number of wheels
1
Number of wands per wheel
10
LED power
12 x 1W RGB
Dimensions
550 x 255 x 315cm
Weight
6.7kg
Troubleshooting:
No power to main unit
Check mains voltage is correct and socket is switched on
or wired controller
Check IEC lead is OK and connected properly
Check mains fuse in IEC connector and fuse in plug top
If fuse blowing repeatedly, refer to qualified service personnel
Power to unit but no
Check fluid level in tank/reservoir
haze/bubble output in
If fluid is OK and pump working, the lines may be blocked
manual or continuous
Check that output is not set to zero on the control panel
mode
Check that output is not switched off on the keyfob remote
If blocked, clean with cleaner & distilled water
Check that if DMX mode is selected, the DMX channel is correct
In DMX mode, check that haze output is not set to zero
