Hardware Installation
3. Product Installation
96
www.qtech.ru
❖
Install the AC power system on QSW-7605
1.
Loosen the captive screws on the blank panel covering the power slot at the rear of the
chassis.
2.
Insert the power module into the slot along the rail until the power module clicks into
place.
Figure 3-12 Installing AC Power Supplies on QSW-7605
The total power of power supplies of the QSW-7600 must be greater than the working
power of the host. Otherwise, some modules may fail to start.
The host power is the summation of the power of all working modules, including the
supervisor module, service module and fan. For the power consumption of each module,
see the module specifications.
3.10
Installing Fans
QSW-7608 and QSW-7605 adopt QSW-M08-FAN and QSW-M05-FAN module for heat
dissipation respectively. Before the following procedures, wear an anti-static wrist strap close
to your skin and have it properly grounded.
❖
Steps for installing the QSW-M08-FAN fan tray:
1.
Install the fan tray into the fan slot in the rear panel of QSW-7608. Note the direction
identifier of the fan tray’s name to ensure the
correct direction.
2.
Tighten the captive screws on the fan tray with a screwdriver.
3.
Figure 3-13 Installing QSW-M08-FAN Fan Tray
