Hardware Installation
3. Product Installation
95
www.qtech.ru
QSW-PA460I-F. Before performing the following procedures, wear an anti-static wrist strap
close to your kin and keep it grounded well.
The QSW-7608 power system provides four power supply slots, which support 1+1
redundancy. The power system also provides two PoE ports.
The QSW-7605 power system provides two power supply slots, which support 1+1
redundancy.
When QSW-7608/QSW-7605 is powered up by more than one source, the power must be
in the same model.
If you want to carry or lift the power module, please hold the bottom of the module with
your hand instead of carrying the module by the handle. Otherwise, the module may be
damaged.
Before inserting or removing the power module, please verify whether the switch is well
mounted. The switch is high, avoid switch tumble when you are inserting or removing the
power module.
If you want to hot swap a power supply, please make sure that the interval between two
operation is greater than 30 seconds.
Please do not touch the connecting finger part of the power supply which is removed after
power off in case that capacitor discharge is not full.
❖
Install the AC power module on QSW-7608
1.
Loosen the captive screws on the filler panel covering the power slot at the rear of the
chassis.
2.
Insert the power module into the slot along the rail until the rear connector of the power
module stays in good contact with the rear panel.
3.
Tighten the captive screws on the power module to fix it.
Figure 3-11 Installing Power Supplies
❖
Install the PoE power system
Take the same installation steps as the AC power installation.
