QSC BASIS 922dz, Hardware Manual

Page: 6 / 28

6
Third, the BASIS 922dz and QSControl.net system are targeted at network switch deployments. The consumer costs of Ethernet
switches have continued to fall over the last several years and are now comparable with repeaters on a per port basis. In addition, the
sophistication and scalability of network switches make them ideal for new installations. However, we do realize that designers may
wish to add BASIS products to existing audio network installations that are built on repeater LAN topologies. This applies primarily to
existing CM16a and RAVE networks. For this very reason we continue to support connectivity to network repeater hardware with the
BASIS 922dz. Support for network repeaters exists only with the Two Wire Interface and only with the standard CobraNet forwarding
latency. That is to say that the QSControl port and the CobraNet port must be connected to separate repeater LANs. Even when properly
configured, audio channel capacity is severely limited and both audio and control network expansion is limited by the respective capac-
ity of each segment. In other words, scalability ceases to exist when bandwidth demands on the QSControl.net segment approach 10
Mbps and demand on the CobraNet segment approaches 100 Mbps. Obviously, we recommend taking advantage of switch network
technology whenever possible.
It should be noted here that while the CobraNet port on a BASIS 922dz is restricted to repeater LAN or switch LAN deployments,
QSControl.net is a TCP/IP standards-compliant network system and therefore supports operation on network repeaters, switches and
routers. When implementing the Two Wire Interface, the QSControl.net segment does not require a single topology data path and
therefore repeaters, switches and routers may be assembled on the LAN in a hybrid fashion.
To learn more about network design rules and system compliance visit the QSC network resources page at http://www.qscaudio.com/
products/network/resources.htm. To learn more about CobraNet design requirements and to obtain the CobraCAD system design utility
visit the Peak Audio website at http://www.peakaudio.com/CobraNet/Network_Design.html.
All of this may seem daunting if you are new to networking. However, it all boils down to connecting a few simple cables between var-
ious networking devices. Most of the time it "just works". QSC helped pioneer CobraNet with our RAVE ™ products and there are hun-
dreds of installations all over the world, in theme parks, hotels, stadiums - everywhere. They run hum-free, sound great and are very
reliable.
The following examples will help get you started, but they just scratch the surface of what can be achieved with advanced network-
ing…
Example #1 - QSControl.net X-over mode:
This is the simplest connection you can make between the BASIS 922dz and your computer. Use a CAT-5 crossover cable connected
between the BASIS QSControl port and your computer's Network Interface Card, (NIC). No network switch is required. With QSCon-
trol.net server and client software installed and running on your computer you will be able to completely set up and monitor your BASIS
922dz.