CAI-QMICR-01: QMicro Receptacle Connector Customer Assembly Instructions
Page 10 of 13
BACKSHELL (4.5mm – 7.5mm Cable Option)
CABLE PREPARATION
Slide the components onto the cable
in the following order
(See image on right):
1. Bend Limiter
2. Backshell
3. Cable Seal
4. Washer
5. Strain Relief
6. Wave Spring
STRIP CABLE
Strip cable jacket approximately 3” (76 mm) from end and place Crimp Support over fiber and Kevlar so
that it stops at the end of the jacket. Bend Kevlar back over the Crimp Support. Slide second Crimp
over Kevlar and Crimp Support and secure with tape for crimping after termination and polishing.
