Sign-in-China.com
Online Wholesale for AD & Signage Products
Learn More >>
- 24 -
8. For the issue in above picture indicates the pressure is too small, please increase
pressure to improve
9.
If the image is off-tracking on the left right of the machine, it indicates the pressure on
the left side is higher than that on the right side, please decrease the pressure (see
chapter 4).
10. No need heating for cold lamination film. If your working condition is lower than 10°C
(50°F), please heat to 40°C (104°F) to get satisfied performance.
VII. Problems and Solutions
First of all, please check if any destroy parts on your machine, if so, repair the broken part
then run the machine.
Trouble
Reason
Solution
Although the main is plugged in and
the power-on button is pressed, the
LED does not light up.
The power plug is not well-
connected.
Check the plug to ensure
connection.
The voltage of the main does not
adaptable to the required voltage.
Check the voltage of the main to
ensure its adaption to the machine.
Emergency stop is not switched on. Turn on the emergency stop.
The fuse link beside the power
cable is un-installed or damaged.
Check the fuse to ensure it is not
damage.
The power is connected; air break is
turned on but trip.
The heater in the top roller is
damaged which leads to short
circuit.
Check and replace a heater.
