qolsys.com/qz2160840
Force Calibration:
- Force calibration is set automatically when first
actuated.
- To manually re-calibrate, Tap and hold the touch
sense button for 5 beeps, then quickly Tap it 5
times in a row. The water valve will open/close
1 to 2 cycles, followed by 2 beeps.
If you are installing the IQ Water Valve
outdoors, the touch sense button
should be disabled to prevent rain
drops from activating it.
Document#: IQWATERVALVE-QG-12-20
Revision#: 06/01/21
Issue Date: JUNE 2021
Qolsys Product #: QZ2160-840 & QZ2160-724
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2AUZX-BVSZWU
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
CONTACT TECH SUPPORT
GOT QUESTIONS?
TROUBLESHOOTING
OUTDOOR INSTALLS
Touch
Sense
Button
To Disable the Button:
- Tap and hold the touch sense
button for 3 beeps, then quickly
Tap 3 times in a row.
- If successful, the Yellow LED will flash once, then the Red LED
with 1 beep. The LED will then slowly flash Yellow indicating the
touch sense button has been locked.
To Re-Enable the Button:
- Tap and hold the touch sense button for 3 beeps, then quickly Tap
3 times in a row.
- If successful, the Yellow LED will flash once, then the Red LED
with 3 beeps. The LED will then slowly flash Green (if enrolled)
indicating the touch sense button has been unlocked.
LED Status:
- Flashing Yellow: Not yet included into the Z-Wave network or the
touch sense button has been disabled.
- Flashing Green: Included into the Z-Wave network.
Factory Default:
- Option 1: Use the IQ Panel to “Clear” the IQ Water Valve. This will
remove it from the Z-Wave network and restore factory defaults.
- Option 2: Tap and hold the touch sense button for 10 beeps, then
quickly Tap it 5 times in a row. If successful the Yellow LED will
flash once, followed by the Green LED and a long beep.
Scan for more info
