QMS Crownnet, Setup Manual

Page: 37 / 86

Interface
Configuration
35 QMS CrownNet Setup Guide
2 In the Administration/Communications/ xxxxxxxx NIC/Crown-
Net/NetWare/Config PServer/PServer Name[1], PServer
Name[2], and PServer Name[3] menus (where
xxxxxxxx is
either Resident or Optional), enter the name of the bindery
print server.
» Note: The three PServer Name[x] menus allow you to identify
one print server with a name up to 47 characters long. (Up to 16
characters can be entered in the first two menus and 15 in the
third menu). You cannot use these 3 menus to identify 3 print
servers.
Spaces and lowercase characters are not allowed in print server
names. However, underscore characters (_) are allowed to
simulate multiword names (for example, PUBS_PSERVER). At
the printer control panel only, a space must be used following the
last character of the print server name to end the name. For
example, the print server name
FIRSTGROUP_GROUPS_GRAY_TEAM_TEAMS_CRC_QMS
is 42 characters long, and must be entered as follows:
PSERVER Name[1]
FIRST_GROUP_GROU
PSERVER Name[2]
PS_GRAY_TEAM_TEA
PSERVER Name[3]
MS_CRC_QMS<space>
where <space> is the space character.
If you want the server to operate in an Rprinter mode, go to step
3. Otherwise, go to step 5
3 In the Administration/Communications/ xxxxxxxx NIC /
CrownNet/NetWare/RN Printer#1/Printer Slot # menu (where
xxxxxxxx is either Resident or Optional), enter the printer
slot number.
» Note: This number must match the slot number chosen in the
Printer Configuration submenu of the Print Server Configuration
menu in the NetWare PCONSOLE utility.