P
reli
mi
na
ry
Loading New Switch Control Code into Flash
SANbox-8/16 Switch Management
User’s Manual
59010-06 Rev. A
TFTP
4-7
Loading New Switch Control Code into Flash
Load new flash code only under the direction of QLogic Customer Support.
QLogic will make this code available over the Internet. Move this executable
module into your local management station.
If the file transfer succeeds, the new Switch control code is saved in the Switch
flash, and will be executed the next time the Switch is reset. A reset operation takes
place when the Switch power is cycled, or when reset using TFTP. Refer to the
reset paragraph on the next page.
If the Switch load process fails for any reason, the Switch control code saved in the
Switch flash is not valid and must be reloaded. If the Switch is reset with an invalid
control code in the Switch flash, it will automatically enter PROM mode. In
PROM mode, the Switch will not switch data traffic through the Fibre Channel
ports until a valid executable module is downloaded.
Windows
Perform the following sequence of events:
Where: IP address = the actual IP address of the Switch
file.fls = the file name with a .fls extension, provided by QLogic
d:\temp>
tftp -i <IP address> put <file.fls> load <R>
TFTP Session closed
d:\temp>
tftp <IP address> get reset <R>
(reset the switch)
TFTP Session closed
d:\temp>
Unix
Perform the following sequence of events:
Where: IP address = the actual IP address of the Switch
file.fls = the file name with a .fls extension, provided by QLogic
#
tftp <R>
tftp>
connect <IP address> <R>
(Where: <IP address> = the actual address
of the switch being accessed)
tftp>
binary<R>
(Enter the binary mode)
binary mode
tftp>
put <file.fls> load<R>
(transfer the file)
transferred xxx bytes in x.x seconds
tftp>
put reset <R>
(reset the switch)
tftp>
quit <R>
(exit tftp)
#
Summary of Contents for SANbox-16
