Qlogic 8200 Series, User Manual

Page: 32 / 130

1–Product Overview
Multi-boot Image for 10Gb CNA—CNA Function Configuration Utility
1-10 SN0054671-00 A
Initiator Settings

Enable DHCP (
Enabled/Disabled: Default—
Enabled
)
When
Enable DHCP
is set to
Enabled
, the adapter utilizes DHCP to obtain
its IP address, subnet mask, and gateway IP address.

Target Param From DHCP
(Enabled/Disabled: Default—
Enabled
)
When
Target Param From DHCP
is set to Enabled, the adapter uses
DHCP to obtain the target IP address, subnet mask, and gateway IP
address.

Initiator Name
(Programmed during manufacturing)
Enter to modify the iSCSI name of the initiator.

Initiator IP Address
When
Enable DHCP
is set to
Disabled
, this field must contain a valid IP
address.

Initiator Subnet Mask
When
Enable DHCP
is set to
Disabled
, this field must contain a valid
subnet mask.

Gateway
When
Enable DHCP
is set to
Disabled
, this field must contain a valid
gateway address.

Reverse CHAP Name
Enter to configure bidirectional CHAP name.

Reverse CHAP Secret
Enter to configure Bidirectional CHAP secret.
Primary/Secondary Target Settings
When
Target Param From DHCP
is set to
Disabled
, enter to manually
configure the target parameters.

Target Name
Enter to specify the iSCSI name of the intended boot target. (Depending on
your configuration, it may not be necessary to configure this option).

Target IP Address
This field must contain a valid IP address of the intended iSCSI boot target.

Target Port
Enter to specify the port used by the target. (By default, iSCSI uses
port 3260—do not modify this unless it is necessary.)