TissueLyser II User Manual 05/2016
33
For the optimal disruption time for your application, see the
TissueLyser Handbook
.
7. Press the “START” key on the keypad. The TissueLyser II will now operate at the frequency
specified in step 5. In addition, the “Time min/sec” display will count down the disruption
time (i.e., the display shows the time remaining). If necessary, the disruption time can be
adjusted while the TissueLyser II is in operation.
Note
: The TissueLyser II will not start if the transparent hood has not been lowered.
WARNING
Moving parts
Do not leave the TissueLyser II unattended during operation.
8. When the remaining time on the “Time min/sec” display reaches zero, the TissueLyser II stops
operating. The display resets to display the disruption time for the previous disruption
procedure carried out.
To pause the TissueLyser II before the remaining time reaches zero, press the “STOP” key on
the keypad. To continue operation of the TissueLyser II from the time remaining, press the
“START” key.
To cancel operation of the TissueLyser II, press the “STOP” key twice. The TissueLyser II then
goes into standby mode. When the “START” key is pressed again, the display is reactivated
and the disruption time for the previous procedure is displayed.
9. When the TissueLyser II is no longer in operation, switch it off at the power switch.
Storing disruption parameters
The TissueLyser II has an internal memory which has 9 storage locations to store disruption
parameters (i.e., disruption time and oscillation frequency). To store disruption parameters, follow
the procedure below.
1.
Switch on the TissueLyser II. “on” appears in the “Memory” display.
2.
Press the “PROG” key repeatedly until the desired storage location in the memory is displayed
(i.e., “P1” to “P9”).
3.
Press the “SET” key. This causes all displays to flash.
4.
Set the disruption time and oscillation frequency using the “+” and “–“ keys on the keypad.
Note
: To cancel the operation, press the “PROG” key. The disruption parameters selected will
not be stored.
