KidGoo1 – Q8000-S
Subject to change. – 05|2016 –
19
Assembly
Optional assembly steps
Installing the buggy wheel
You need the buggy wheel for Buggy and Walker mode. It consists of two components:
The wheel suspension is fitted to the wheel mount of the cabin frame by means of a quick-
release clamp.
The wheel itself is inserted into the wheel suspension and is mounted so that it can rotate
through 360°. The mode switch at the front enables you to optionally remove or lock the
wheel, see
“Adjusting the buggy wheel” on page 27
f
Tilt back the cabin and place it on its reverse side. This
makes the lower cabin frame accessible for assembly.
f
Release the quick-release clamp of the wheel
suspension.
f
Push the wheel suspension as far as it will go into the
cabin frame’s wheel mount.
f
Secure the connection with the quick-release clamp.
f
Check whether there is sufficient air in the buggy wheel (maximum air pressure: 2 bar).
If necessary, use an air pump for car valves to top up with air.
Mounting the tow bar
You only require the tow bar in Trailer mode. It is used to hook up the
KidGoo1
behind a bicycle
equipped with a suitable coupler, see
“Connecting the trailer to a bicycle” on page 30
The tow bar is screwed into the tow bar mount with a screw and a star grip nut and can be folded
into two different positions:
Attachment position: The tow bar is facing forwards.
Standby position: The tow bar is facing to the rear and is carried under the cabin floor.
In both positions, the tow bar is also secured with a cotter pin.
f
Tilt back the cabin and place it on its reverse side. This makes the tow bar mount on the lower
cabin frame accessible for assembly.
f
Loosen the star grip nut and remove the washer, the spring lock washer and the screw from
the tow bar mount.
f
Remove the retaining cotter pin from the tow bar.
f
Hold the tow bar on the tow bar mount so that the
following conditions are fulfilled:
–
The curve of the tow bar faces inwards.
–
The holes in the tow bar mount and tow bar are
precisely aligned with each other.
f
Insert the screw from the inside through the holes in
the tow bar mount and tow bar.
f
Place the spring lock washer and the washer on the outside onto the screw and screw the star
grip nut loosely into the thread.
