14
– 05|2016 – Subject to change.
KidGoo1 – Q8000-S
Assembly
Below you can read all the information that you will need to assemble your
KidGoo1
properly.
f
Make sure that you have sufficient space to assemble it.
Also pay attention to the door width at the place of installation: The
KidGoo1
is 76 cm wide
with the wheel guards fitted.
f
Have a size 4 hex key and a medium-sized Phillips screwdriver to hand (not supplied).
f
Perform each of the instructions step by step.
f
If necessary, follow the QR code to call up a video
about assembly and operation on the Internet. Using
the
Jumbo 1 Kid
as an example, the video shows a few
functions that also apply to the
KidGoo1
:
Danger!
Never perform assembly work if there is a child in the cabin. Keep children away from
the vehicle during assembly.
When handling moving components, make sure that your hands or fingers do not get
trapped.
Unfolding the cabin
f
Place the collapsed cabin in the assembly area.
f
Position yourself behind the cabin.
f
Pull both sides of the rear cabin frame all the way up.
f
Open the storage space cover.
f
Pull the lower horizontal bar backwards evenly until
the two red locks on the left and right engage audibly.
Installing wheel axle and push handle
Caution!
In the as-delivered state, the wheel axle and the push handle are connected via the
brake cable. To avoid damaging it, you should place the push handle on the floor
behind the cabin when assembling the wheel axle.
