Qeedji SAP10e, User Manual

Page: 21 / 58

21
◬
If the SLATE does not appear in the list after 15 minutes, either they are too far from the SAP10e device or the wake-up policy configuration
does not allow to wake up now. For further information, refer to the
SLATE106 User manual
on the Qeedji Website .
In the
SLATEs detected
left table, these parameters values are shown:
a check column: allows to select one or several SLATEs. Selecting a SLATE allows to drop it in the right table.
PSN
: SLATE Product Serial Number,
Hostname
: name of the SLATE in the WPAN network,
RSSI
: Received Signal Strength Indication (in dBm)
Auth.
:
PIN code
: a pairing
PIN code
is required to pair the device,
None
: no pairing
PIN code
is required to pair the device.
State
:
 Unpaired
: the SLATE having this PSN is not paired to the SAP10e device,
 Paired
: the SLATE having this PSN is paired to this SAP10e device,
 Paired to another device
: the SLATE having this PSN is paired to another device.
☛ The RSSI (in dBm) allows to have a first estimation of the WPAN connectivity quality between SLATEs and the SAP10e device. The RSSI values
estimated for each SLATE can go roughly from -30 dBm for the nearest SLATEs to -90 dBm for the farthest SLATEs.
b) Pair all the required SLATEs
To pair the required SLATEs to this SAP10e, you have to select them, identified by their PSN in the
SLATEs detected
left table, and drop them into the
SLATEs paired to this device
right table.
In the
SLATEs paired to this device
right table, these values can be shown for each SLATE:
a check column: allows to select one or several SLATEs. Selecting a SLATE allows to access to further menus for these SLATEs.
#
:
Index
from 1 to 10,
PSN
: SLATE Product Serial Number,
Hostname
: name of the SLATE in the WPAN network,
RSSI
: received Signal Strength Indication (in dbm),
Quality
:
Quality of connection
:
Green
: the connection quality is good. The file download success rate between this SLATE and the SAP10e device is between 75% and
100%.
Orange
: the connection quality is average. The file download success rate between this SLATE and the SAP10e device is between 50% and
75%. The download error rate has reached a threshold that can affect the file download success rate meaning that in some case, the
APPLI.CFG file or the content may not be updated for sure within the 15 minutes interval,
Red
: the connection quality is bad. The file download success rate between this SLATE and the SAP10e device is between 0% to 50%. The
download error rate has reached a threshold that affects seriously the file download success rate meaning that the APPLI.CFG
configuration or the content will be not updated within the 15 minutes interval. The SLATE can not be used in this condition. It is required
to install the SLATE at another location or install a new SAP10e device closer to this SLATE.
Grey
: not yet determined (value shown in the tooltip).
In the
SLATEs paired to this device
right table, move up or move down the SLATEs so that they match the
Index
you have defined in the paragraph
above Prepare SLATE pairing configuration .
☛ By default, after a new SLATE dropping, the SLATE configuration leads to
Test card
inactivated and no pairing
PIN code
required.
Select one or several SLATEs in the
SLATEs detected
left table.
Then drop them into the
SLATEs paired to this device
right table using the right arrow button

1
.