Appendix A: Optional Systems/Accessories
Page 35
Revision 1 – December, 2007
Skimmer Manual
High-Water Shut-Off (HWSO)
A High-Water Shut-Off (HWSO) option may be added to the pump system. If a
High-Water condition exists that causes the skimmer float to rise to its upper range
of travel, air is turned off to the Genie pump. This prevents water from entering the
product line. When the water level drops back to the normal range, the skimmer
float starts dropping with the lower water level and the air is turned back on to the
pump system.
•
Included with the HWSO option is a well level sensor hose (yellow). This hose
runs from the control box to the skimmer to sense the fluid level in the well.
•
Also included is a High-Water Shut-Off (HWSO) indicator. This indicator is
located on the outside of the control box. When the indicator is green, the system
is ON; when the indicator is red, the fluid in the well has risen 11 inches above
the level sensor bubbler hole on the skimmer, and the automatic cycling of the
pump has been stopped. If more that one skimmer is being used, the operator
must select the one to have the well level sensor hose. Unless the controls are
modified, only one skimmer can be monitored.
C100M
Programmable Solar / Electronic Controller complete with high air flow bypass valve
and quick-connect fi ings. Powered by sunlight or a 110 volt outlet. Intrinsically
safe in solar powered mode.
Can be used with any pneumatic pump(s) to regulate and pump operation.
CTRTFO
Tank-Full Shut-Off Kit, to be used in combination with the Model C100(M) Digital
Controller.
•
Includes tank level shut-off switch, 100' of sensor cable, and fi ings to tie into the
C100(M) Controller and product recovery tank. Not for use with "Auto Genie"
or other controllerless pumps.
