12
QDI
Installation Instruction
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX12V power supply
and a LAN adapter which supports this function are used. Then connect this header to the
relevant connector on the LAN adapter, set Power on by Ring/LAN as Enabled in the
POWER MANAGEMENT SETUP section of the CMOS SETUP. Save and exit, then boot
the operating system once to make sure this function takes effect.
Wake-Up On Internal Modem (WOM)
Through this function, the system which is in the suspend or soft-off status can be waked up
by a ring signal received from the internal modem. When this function is used, be sure an
internal modem card which supports this function is used. Then connect this header to the
relevant connector on the modem card, set Power on by Ring/LAN as Enabled in the
Power Management Setup section of the CMOS SETUP. Save and exit, then boot the
operating system once to make sure this function takes effect.
Signal for waking up
WOL
+5V standby
GND
Signal for waking up
WOM
+5V standby
GND
1
All manuals and user guides at all-guides.com
